Your blind will come with installation brackets and screws. Follow these steps for an easy installation:

1. With each blind you will receive two brackets - one male (Fig 1) and one female (Fig 2). The male bracket is used for the chain control side of the blind. The female bracket mounts on the pin (non-control) end.
2. Hold the brackets (Fig 5) to the place on your window frame where they are to be fixed. With a pencil mark the two screw holes for each bracket.
3. Drill a pilot hole in the middle of each marking with a 2mm drill bit.
4. Now use the screws provided to fix the brackets to the window frame as per Fig 6 &7.
5. Remove the blind from tube.  Do not remove securing tape from assembly at this stage.
6. Install your blind into the male bracket first (Fig 1) which is also the chain end. Before inserting the blind into the bracket make sure the top of the chain drive is facing upward (Fig 3).
7. Remove securing tape from the blind.
8. Hold the chain end in position and move to the other end of the blind. Guide the metal spring loaded pin (Fig 4) into the track of the female bracket until it clicks into position. 
9. Your blind is now installed - it can now be lowered using the chain control.
10. Once lowered place the plastic chain stop on the chain where it enters the chain drive. This will prevent the blind from being rolled down too far.

1. With your blind you will receive two brackets - one male (Fig 1) and one female (Fig 2). The male bracket is used for the chain control side of the blind. The female bracket mounts on the pin (non-control) end.
2. Hold the brackets (Fig 5) to the place on your window frame where they are to be fixed. With a pencil mark the two screw holes for each bracket.
3. Drill a pilot hole in the middle of each marking with a 2mm drill bit.
4. Now use the screws provided to fix the brackets to the window frame as per Fig 6 &7.
5. Remove the blind from tube.  Do not remove securing tape from assembly at this stage.
6. Install your blind into the male bracket which is also the chain end, making sure that the opening for the chain is facing downwards two lines at the top of the chain drive are facing upward (Fig 3).
7. Remove securing tape from the blind.
8. Hold the chain end in position and move to the other end of the blind. Guide the metal spring loaded pin (Fig 4) into the track of the female bracket until it clicks into position.
9. Your blind is now installed - it can now be lowered using the chain control.
10. Once lowered place the plastic chain stop on the chain where it enters the chain drive. This will prevent the blind from being rolled down too far.

To remove the blind, turn the large wheel at the pin end (Fig 8) anti clockwise. This action will slide the metal pin inward and the blind will slide out of the bracket.